Home > About Antennas Direct > Product Info > Assembly Info > DB2

    DB2 Assembly Instuctions

    Antenna Amplifiers will perform best when connected properly. Remember an amplifier cannot create a signal. It will help over come the loss caused from cable runs and splitters.

    DB2 Antenna Assembly

    The DB2 comes with:

    • 1 set of reflectors
    • 1 set of 2 elements with transformer and weather boot.
    • 2 sets of 4" bolts with aluminum sleeves
    • 1 Mast clamp
      
    DB2 Antenna Assembly

     

     

    Feed bolts trough the holes on the square tube and slide the aluminum spacers over the bolts.

      
    DB2 Antenna Assembly

     

     

     

    Attach the reflector panel to the elements using the supplied bolts.

      
    DB2 Antenna Assembly

     

     

     

    Assembled DB2: Make sure elements (bowties) are facing transmitting towers.

    Tip: If your cable run is greater than 75', A UHF pre-amplifier may be required.